Enjoy making repairs with Tenacious Tape Gear Patches. Available in a variety of fun shapes and sizes, including the elusive Sasquatch. With these stick-on patches, jacket repair has never been easier. Just peel and stick. No sewing, ironing or heat-setting required. Quickly personalize puffy coats, backpacks and ski pants with these decorative patches. Like all Tenacious Tape, it has an ultra-strong adhesive that stays put no matter the weather. Put it through the wash or run them through the dishwasher, it stays stuck. Skip the messy duct tape. Instead, add some personality to your favorite outdoor gear with Tenacious Tape Gear Patches. Available in a variety of shapes and sizes on four 7.6 x 50 cm black nylon strips.

Features:

• Instant & Fast Fix rips and tears quickly and personalize gear like water bottles and luggage with wildlife, animal and geometric shapes
  
• Peel & Stick No sewing skills or heat required; simply remove backing and apply to surface with pressure
  
• Durable Ultra-strong repair tape permanently bonds to outdoor fabrics and materials including nylon, vinyl, and polyester
  
• Washable Fabric tape is sealed with a waterproof coating and wont peel off during a wash or a storm
  
• Multipurpose Sticks to almost any surface to repair puffy coats, tents, sleeping bags, and backpacks

APPLICATION:

1. Begin by cleaning the repair area with isopropyl alcohol to remove any dirt or body oils which may prevent a good bond. Trim any loose threads.
   
2. Apply the Tenacious Tape patch over the rip, tear or hole.
   
3. Smooth out any bubbles and ensure the edges lay flat. The adhesive will reach full strength after 24 hours.
   
4. For large holes, repeat the above steps on the opposite side of the fabric.

What does it stick to?

• Nylon
  
• Polyester
  
• Vinyl
  
• Canvas
  
• Rubber
  
• Bicast Leather (PU Leather)
  
• Non-Oiled Leather
  
• Neoprene
  
• Vinyl Plastic (PVC)
  
• TPU
  
• EVA Plastic
  
• PET Plastic
  
• OPP Plastic
  
• CORDURA
  
• Sunbrella
  
• WINDSTOPPER
  

How to remove backing:
There is a perforation that runs down the middle of the tape. Simply fold the tape on either side of the fold and remove the backing. It is best to peel away the backing from the top of the tape where the Gear Aid logo appears.

How to remove a repair patch:
These repair patches feature an ultra-aggressive adhesive designed to stay put. For added strength, you can use heat (clean iron on low setting) on our GORE-TEX Fabric Repair Patches and Gear Patches.

Need to remove a patch? Tenacious Tape utilizes a clean-adhesive technology meaning it shouldnt leave behind any residue once removed.

The easiest way to remove these patches is to have the garment dry cleaned. If dry cleaning is not recommended or does not entirely remove the patch the first time, try the following:

1. Warm the patch for 30 seconds using an iron set to low heat. Use moderate pressure and a circular motion to heat evenly.
   
2. Quickly lift up an edge or corner and pull slowly but firmly across the patch. Be careful not to cause further damage to the original repair.
   
3. After the area has cooled, remove any residual adhesive with rubbing alcohol and a terry cloth. Rub in a circular motion for at least one minute until the adhesive has lifted.
   
4. Note: When applying Revivex Water Repellents to repair patches, the repellent may soften the patch adhesive. In most cases, allowing the garment to dry overnight without disturbing the patch will restore adhesion.

Storage & Care:
Place unused patches in included bag and store in cool, dry place.

Gear Aid Tenacious Tape Gear Patches - Camping 91121-GA